P
pierojump
New Member
- Messages
- 2
- Reaction score
- 0
Hello to everyone,
is there someone that mill crown straight from the scanned impression without pour and scan model?
And in case, which scanner you use it?
I have at the moment a Zirkonzahn s600 but it is not the best to scan impression due to the only two cameras. I'm looking to buy a new scan and I would like to know if someone use a full digital workflow with good results.
Thanks
is there someone that mill crown straight from the scanned impression without pour and scan model?
And in case, which scanner you use it?
I have at the moment a Zirkonzahn s600 but it is not the best to scan impression due to the only two cameras. I'm looking to buy a new scan and I would like to know if someone use a full digital workflow with good results.
Thanks