zero_zero
Well-Known Member
Full Member
- Messages
- 6,293
- Reaction score
- 1,397
Wondering what temps/hold you guys use. We rarely do PFM's these days, yet alone NP metals...
I don't oxidize.just sandblast and apply your opaque.Wondering what temps/hold you guys use. We rarely do PFM's these days, yet alone NP metals...
Who did you buy it from ?bredent Cerambondliner,
BredentWho did you buy it from ?
I know, local Brendent distributor won't sell b/c is not Health Kanada approved...Bredent
It's not a magic product. Use high fusing porcelain for 1/20 of the cost.I know, local Brendent distributor won't sell b/c is not Health Kanada approved...
As mentioned, no oxide cycle on NP (CoCr) metals. First firing cycle is the wash cycle. In fact, you may have to steam off the greenish oxide off the wash, that is built up. Once done, you should be good to go...Wondering what temps/hold you guys use. We rarely do PFM's these days, yet alone NP metals...
The best part is that the higher temps burn off the dust that's accumulated over the years.It's not a magic product. Use high fusing porcelain for 1/20 of the cost.