Collab question

E

edwarddental

Active Member
Full Member
Ratings
34 1
#1
Is there option in Collab2017 to scan scanbody one by one for large cases?
 
RCKSTR

RCKSTR

Well-Known Member
Full Member
Ratings
352 4
#2
I think your only option is to use the multi die holder and align them to the base scan
 
J

Jack_the_dentureman

Member
Full Member
Ratings
22
#3
Simple scan and cut area where you have no scanbody. Then swich scanbody position and add scan without delete previous scan.
 
R

Rosa Utset

New Member
Full Member
Ratings
4
#4
Hello Edward!
There are two ways:

1) If you have flexible Multi-die, you can use ‘Shortage’
image003.jpg
You can find a detailed explanation in User Guide page 220
image005.jpg
2) The second option is using 'Re-scan'
a) Select 'Together'
image011.jpg

b) Scan model with a scan body
image013.jpg

c) Move a scan body to another position.

d) Click ‘Rescan’
image014.jpg

e) Click ‘NO’. Very important to not mess up with this step!
image019.jpg

f) You can see 2 scan body scanning data from a scan body.
image021.jpg
I hope it helps!