T
taylor tori
Member
Full Member
- Messages
- 16
- Reaction score
- 1
There are various zirconia hybrid abutments we are milling in house but not having a ton of success with it. I am using the 3 shape and the companys ti base library and milling the abutment over it
EX. Strauman local milling, Biohorizons, Implant Direct.
We use the Ceramill motion 2 to mill these out.
1st My question is... is there any settings I should be using to avoid breaking the abutments.. I m making sure minimum requirements in 3 shape are being met.. But the abutments are still breaking a lot of the time.
2nd The split files never fit with zirconia abutments! I am increasing cement gaps and playing with settings but they never seems to fit(too tight) ... Is anyone using 3 shape, and the Ceramill and successfully doing split files with this set up? If so any advice or settings?
Thanks everyone!
EX. Strauman local milling, Biohorizons, Implant Direct.
We use the Ceramill motion 2 to mill these out.
1st My question is... is there any settings I should be using to avoid breaking the abutments.. I m making sure minimum requirements in 3 shape are being met.. But the abutments are still breaking a lot of the time.
2nd The split files never fit with zirconia abutments! I am increasing cement gaps and playing with settings but they never seems to fit(too tight) ... Is anyone using 3 shape, and the Ceramill and successfully doing split files with this set up? If so any advice or settings?
Thanks everyone!