Can 3Shape's E4 Scanner work with ExoCAD?

[RVAToothFairy]

Can the E4 work with ExoCAD? I had an awesome experience with this Lab Scanner when I was using 3shape to design, but now I'm ExoCAD.

I Love ExoCAD because I'm mainly designed Full Arch. I hope this is possible. I had the Medit T710 and it's good, but nothing like the E4. Any advice is fully appreciated.

Also Sidenote, does anyone have any experience with the "Degree of Freedom" Scanner Never heard of it, but was asked about it.

 

[TheLabGuy]

Not that I'm aware of, 3Shape only.

 

[sirmorty]

Yeah I don't see why it wouldn't work. Just change the output to .stl instead of
.dcm

Dof is a very popular scanner. Lots of people use it. I have one and prefer it to any 3 Shape scanner.

You can fit a full size articulator.
And the table just rotates and you dont need to use putty.

 

[Andrew Priddy]

yes and no.. you will need 3sheep to run it.. then transfer them.
the argen scanbox was 600 a month
the T-710 is 600 a month to buy

 

[RVAToothFairy]

Yeah I don't see why it wouldn't work. Just change the output to .stl instead of
.dcm

Dof is a very popular scanner. Lots of people use it. I have one and prefer it to any 3 Shape scanner.

You can fit a full size articulator.
And the table just rotates and you dont need to use putty.

Awesome! I’m glad you gave your input on DoF because I haven’t really heard too much about it! Thank you!