Axsys/Arum 5X500 losing calibration

A2WILLDO

A2WILLDO

Member
Full Member
Messages
34
Reaction score
0
Anyone with a Axsys/Arum 5X500 having issues with milling quality? Getting the mill to successfully auto calibrate? Able to manually calibrate Z, B, Y and not have to do it again the next day?

(A) Yes
(B) No
(C) Its Complicated
(D) All the Above
 
CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
yes, we're aware and we're working on it.
 
CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
would rather this was a private convo but yes, its a bit complicated. Cameron found an inconsistency in the PLC of the mill, and Arum took a while to figure out what could be done to fix it. we have what we think is a fix for you right now, but we're attempting it internally first before we roll it out to you.
 
A2WILLDO

A2WILLDO

Member
Full Member
Messages
34
Reaction score
0
Hi A2WILLDO
Did you talk to our tech support team.
Hey Al,
Yes I have and you guys have a great team, I really appreciate all of you. Just trying to get a feel for the room and see if any hackers out there found any new tricks.
 
A2WILLDO

A2WILLDO

Member
Full Member
Messages
34
Reaction score
0
would rather this was a private convo but yes, its a bit complicated. Cameron found an inconsistency in the PLC of the mill, and Arum took a while to figure out what could be done to fix it. we have what we think is a fix for you right now, but we're attempting it internally first before we roll it out to you.
Sweet! Didn't know you guys were actually on here.Pcguru
 
Top Bottom