millennium
Active Member
Donator
Full Member
- Messages
- 878
- Reaction score
- 78
Thank you, how do I get this to my exocad?2mm ball attachment, scale it to your needs... good luck milling it
Dude, seriously, you're just about never gonna get that to mill out unless you put it on a shaft sticking out of the crown that is at least 3x wider than the burr diameter. And it won't be near as strong as a metal ball would be , nor like on a precision attachment of old school cast and solder pfm ways.Thank you, how do I get this to my exocad?
First of all thank you for all the replies.Dude, seriously, you're just about never gonna get that to mill out unless you put it on a shaft sticking out of the crown that is at least 3x wider than the burr diameter. And it won't be near as strong as a metal ball would be , nor like on a precision attachment of old school cast and solder pfm ways.
See if you can give him some facts and get him to say 'no' when you tell him you'll have to bill for the 3 pucks you're gonna go through and 5 burs your gonna break.
I am all questions, sorry.I have done titanium telescopic type coping with era attachment and then scanned that as one of the preps on the model. Next make zirconia frame over that coping as regular bridge abutment. You could do the same with Bredent ball attachment if you need to cast rather than mill.
There are other attachment options in exocad libraries as well.
I think I have it, Make the margins around the attachment! Your coping with attachment is a great !I am all questions, sorry.
Wouldn't the program cover the attachment with zirconia? How would I make exocad let me have the attachment come out through Zr frame?