Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
Zirconium
Aidite SHTC three hour cycle?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BitesTheDust" data-source="post: 345262" data-attributes="member: 25763"><p>My lab is looking to sinter batches of ten single units using Aidite's SHTC mono zirconia during the day to be worked on. I am new to programing ovens and was looking for some advice on how to go about creating a custom sinter cycle that could achieve this in three hours. The oven I am using is the Aidite Cameo AGT-L. My understanding is that the oven has to reach 1530 degrees Celsius. Would anyone have suggestions on what the heat up and cooldown rate should be for a three hour cycle?</p></blockquote><p></p>
[QUOTE="BitesTheDust, post: 345262, member: 25763"] My lab is looking to sinter batches of ten single units using Aidite's SHTC mono zirconia during the day to be worked on. I am new to programing ovens and was looking for some advice on how to go about creating a custom sinter cycle that could achieve this in three hours. The oven I am using is the Aidite Cameo AGT-L. My understanding is that the oven has to reach 1530 degrees Celsius. Would anyone have suggestions on what the heat up and cooldown rate should be for a three hour cycle? [/QUOTE]
Insert quotes…
Verification
Who makes the popular shade guide?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
Zirconium
Aidite SHTC three hour cycle?
Top
Bottom