B
BitesTheDust
New Member
- Messages
- 2
- Reaction score
- 0
My lab is looking to sinter batches of ten single units using Aidite's SHTC mono zirconia during the day to be worked on. I am new to programing ovens and was looking for some advice on how to go about creating a custom sinter cycle that could achieve this in three hours. The oven I am using is the Aidite Cameo AGT-L. My understanding is that the oven has to reach 1530 degrees Celsius. Would anyone have suggestions on what the heat up and cooldown rate should be for a three hour cycle?