Aidite SHTC three hour cycle?

B

BitesTheDust

New Member
Messages
2
Reaction score
0
My lab is looking to sinter batches of ten single units using Aidite's SHTC mono zirconia during the day to be worked on. I am new to programing ovens and was looking for some advice on how to go about creating a custom sinter cycle that could achieve this in three hours. The oven I am using is the Aidite Cameo AGT-L. My understanding is that the oven has to reach 1530 degrees Celsius. Would anyone have suggestions on what the heat up and cooldown rate should be for a three hour cycle?
 
KingGhidorah

KingGhidorah

Member
Full Member
Messages
51
Reaction score
0
Contact the manufacturer for speed sintering programs. If you try and make your own program it’ll probably come out too opaque, or a shade lighter than it should be.
 

Similar threads

Top Bottom