AG Zolid FX ML sintering in Programat S1 1600

[Contraluz]

Anybody has firing parameters that I could apply in the Programat S1? Or knows if one of the pre-established programs works with Zolid FX ML?

Thanks in advance,

M

 

[PRO ARTS DL]

For Zolid FX ML the one given by AG is as follows:

450C/hr to 1450C
Hold 120 min @ 1450C
Let cool down on its own to room temp.

This is the program from a Ceramill Therm 3. This one is a front load (?) door type furnace so the door remains closed at all times.

 

[Contraluz]

Thank you! Appreciate!

M