J
JustDavid
Member
Full Member
- Messages
- 32
- Reaction score
- 5
Good afternoon everyone,
I hope y'all are well. I found a few posts but nothing that really fit the bill.
I'm looking for some support or possible DME for implant/tooth bourne model creation in 3Shape to be printed with DLP printer. EnvisionTEC / Rapidshape etc
I've been working off some DME I pull from the Web Formlabs, 3Shape generic etc but the die/analog fit is off too loose on the analog too tight on the dies.
Anyone can point me in the right directions or give me some clarifity about the model builder settings to look out for.
Any help appreciated,
kind regards
JD
I hope y'all are well. I found a few posts but nothing that really fit the bill.
I'm looking for some support or possible DME for implant/tooth bourne model creation in 3Shape to be printed with DLP printer. EnvisionTEC / Rapidshape etc
I've been working off some DME I pull from the Web Formlabs, 3Shape generic etc but the die/analog fit is off too loose on the analog too tight on the dies.
Anyone can point me in the right directions or give me some clarifity about the model builder settings to look out for.
Any help appreciated,
kind regards
JD