M
Murat Alp
Member
Full Member
- Messages
- 32
- Reaction score
- 3
Hi everyone!
I helping a friend with his 3d scanner, D700.
We have upgraded the computer to a laptop, an Asus X53s, 8 GB ram, i7-2670QM, with windows 10, 64 bit.
The computer have double graphic cards and we are using a geforce GT 520 MX.
We have problem with scanned 3d models in 3 shape. The shapes of the scanned models gets wrong when the scanner makes the refinement.
I have attached pictures below to show you how it look likes.
You can see the wrong made surface over the marked tooth. The surface have sharp edges that should not exist. It lacks smoothness.
The models cannot be used cause the surface is to bad.
Have anyone have seent this kind of issue before and what was the cause?
What did you do to fix the issue?
Could it the issue have something have todo with the graphic card, which may not be good enough ?
Or could it be config setting that needs to be done for the graphiccard or 3 shape. Which settings could it be?
Or something else?
I helping a friend with his 3d scanner, D700.
We have upgraded the computer to a laptop, an Asus X53s, 8 GB ram, i7-2670QM, with windows 10, 64 bit.
The computer have double graphic cards and we are using a geforce GT 520 MX.
We have problem with scanned 3d models in 3 shape. The shapes of the scanned models gets wrong when the scanner makes the refinement.
I have attached pictures below to show you how it look likes.
You can see the wrong made surface over the marked tooth. The surface have sharp edges that should not exist. It lacks smoothness.
The models cannot be used cause the surface is to bad.
Have anyone have seent this kind of issue before and what was the cause?
What did you do to fix the issue?
Could it the issue have something have todo with the graphic card, which may not be good enough ?
Or could it be config setting that needs to be done for the graphiccard or 3 shape. Which settings could it be?
Or something else?