Forums
New posts
Search forums
What's new
New posts
Latest activity
Articles
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Lab talk, the good, the bad, and the ugly
3D Printer
3d printed dies undersized, a mystery for the ages.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="KingGhidorah" data-source="post: 339936" data-attributes="member: 25014"><p>N</p><p></p><p>Nothing wrong with being a newbie, I’m a newbie too, just about hitting 3 years myself as well. </p><p>If that’s the case with what’s going on I doubt it’s the margin marking then, but something important to note is that itero reallllllyyyyy sucks at marking margins. Like they are beyond bad at it, I always preview in the itero software and look at the thing pre ditching to make sure they did it correctly. Back at my old lab I had to call and complain like once every week until finally they told me they were putting a note on my account for only one of the managers to mark margins for our cases. Then they ended up being fine after that, but I had too complain up a storm.</p></blockquote><p></p>
[QUOTE="KingGhidorah, post: 339936, member: 25014"] N Nothing wrong with being a newbie, I’m a newbie too, just about hitting 3 years myself as well. If that’s the case with what’s going on I doubt it’s the margin marking then, but something important to note is that itero reallllllyyyyy sucks at marking margins. Like they are beyond bad at it, I always preview in the itero software and look at the thing pre ditching to make sure they did it correctly. Back at my old lab I had to call and complain like once every week until finally they told me they were putting a note on my account for only one of the managers to mark margins for our cases. Then they ended up being fine after that, but I had too complain up a storm. [/QUOTE]
Insert quotes…
Verification
Who do we work for?
Post reply
Forums
Lab talk, the good, the bad, and the ugly
3D Printer
3d printed dies undersized, a mystery for the ages.
Top
Bottom