C
Crown maker Carol
New Member
Full Member
- Messages
- 8
- Reaction score
- 0
When scanning for the bite, it appears to be accurate. When designing and articulating occlusion with the software, articulator is used, adjustments are made as needed. It shows to be accurate and within normal limits on my end as the lab tech. When delivering the crown, occlusion is completely off, needing big adjustments. This concerns me as it compromises the strength of the crown. I have called support for help but coming up empty. I noticed in another thread the response was to use the optimize button in the articulator mode. Should this be done with every case? Any suggestions would be welcome! Thanks!