Hello, we tried to order a new hi speed and found out they don't make them anymore. Did anybody else hear that? No turbines either. Anybody know where we can get a new Grand Hurricane or the turbines? Or which high speed HP do you recommend that has the same torque and speed as the...
The Zahn liquid says it's universal on the can. does anyone know if it will work with most investments? I've used Microstar with Zahn invest. with no problems, I think it's the same stuff, but I have other left over and I'd like to use it up.. Any thoughts? Thx, Dave
Has anyone tried to cast and polish the plastic implant parts? How did they turn out? What metal did you use? I tried one with CrCo and couldn't get it to work. There was no way this Dr. would accept the final abutment. Is it even possible to do? Thx, Dave
A barilium and nickel free from a large supplier on the west coast The two materials were not compatible. and the porc mafg. never mentioned anything about a bonder.
So, just so you know, after looking into this issue and talking to both metal and porcelain people we have been using a metal that's not recommended and also didn't know of a bonder. In the old days we used a bonder at times with NP so I guess that explains the debonding. We have some cases...
After firing it's very dark, then sandblasted. As far as debonding the porc. comes off clean. opaque and porc together, with no oxide on the metal or opaque. I'm still reading trying to figure this out. Thanks again for your help. I know it could something simple. I cast new ingots...
Hey old timers, we've been using a barium/nickal free metal for a long time Lately porc. has been debonding. Opaque and all right down to the metal.. Nothing is sticking to the metal. We cast with a torch and follow the instructions for preparing the metal. Not all the units, but once in...
Thx, People, I have used Dess and they are very accurate. I've been casting for 45 years and have it down. I do a ton of ucla's because that's what these Drs. want believe it or not. I'm going to use Dess again with the work I got in this week. Thx again.
Luke, we currently use cast to gold abuts. The Drs. want that. Most of the Imp. we get are Straumann and Astra. I'm lookine for something that is dependable with the fits being like the stock parts. Have you seen any that have been milled and how do they fit? Dave
I'm in the US. I do a lot of ucla's. The Drs. are concerned about cost now. That's why I'm looking into this. 4 unit, screw retained brdg. with 3 access holes.