5x-400 vs imes 350i vs amann girrbach motion 2

[Alex Sever]

One cuts more with better 1kw but the others are a little bit less expensive.
Please advise on buying.

 

[Affinity]

DOF Sharp2 5x! Best bang for the buck.

 

[DentalTechTips]

I can only comment on the 350i:



However, the makers of the 5x-400 and Motion 2 happen to be sponsors on this site. (so if @brayks or @Amann Girrbach sees my message and want to send me a machine for review purposes, please do )

 

[[email protected]]

Love to talk to you about the 5X-400 from Axsys Dental Solutions also important is the service and support. Contact me or send me your information. 248.926.8810

 

[keith goldstein]

5x-400 all the way

 

[Wainwright]

Depends on what you want to cut... CrCo all day? Only zirconia? Grinding glass?

 

[Alex Sever]

mostly zirconia and peek with some glass and rare titanium abbutments.
Ti bars I think I'll print at the local " shop "

 

[Wainwright]

mostly zirconia and peek with some glass and rare titanium abbutments.
Ti bars I think I'll print at the local " shop "

I'm not a huge fan of grinding glass unless it's for rush cases here and there, but I think all three options are just fine. If you were doing a ton of grinding I'd have some different recommendations.

I'd look into the titanium abutment preform options with each milling machine and make sure the fixture and per part cost makes sense, all three are different and will allow you varying levels of flexibility and cost for this indication. Oh, also CAD support. For example, if you are using Dental Wings you cant mill preform abutments in the AG Motion 2, the CAD output isn't supported but ExoCAD and AG Mind is supported.

Zir and peek are pretty easy and straightforward. Hope this helps, good luck

 

[MolarMania]

I like my Motion 2.. does everything. Make sure your customer service kicks ass!
Otherwise you’ll be kicking yourself in the ass. I’ll promise you that.