GG - J
Active Member
Full Member
- Messages
- 411
- Reaction score
- 14
I agreeContours I think are a lot more important than 15 powder builds
Always thought it would great to take a class
With a single powder build up with emphasis on contours
I agreeContours I think are a lot more important than 15 powder builds
That's LiSi BLE ingot@Al. What was your target shade, and how well did it match? Was it LiSi? BLE, EXW?
Cuspids, eh, maybe. Lats look fine though.this layred A1 ingot.
Looking at these pic I think the laterals and cuspids are over contoured.
But the case went out today already.
View attachment 28355
View attachment 28356
this layred A1 ingot.
Looking at these pic I think the laterals and cuspids are over contoured.
But the case went out today already.
View attachment 28355
View attachment 28356
Excellent Work!!!View attachment 28601 View attachment 28602 View attachment 28603
Tried to get my Al hodges on today lol. Not Nearly as good as al's work but very happy with the result. I wanna give a shout out to him for posting all his great work and techniques on here!
I'd wear'em. Proudly. That's still great work.View attachment 28601 View attachment 28602 View attachment 28603
Tried to get my Al hodges on today lol. Not Nearly as good as al's work but very happy with the result. I wanna give a shout out to him for posting all his great work and techniques on here!
I thought it was Al's at the first sight. Very beautiful, thank you for sharing.View attachment 28601 View attachment 28602 View attachment 28603
Tried to get my Al hodges on today lol. Not Nearly as good as al's work but very happy with the result. I wanna give a shout out to him for posting all his great work and techniques on here!
Thanks! These have ZERO Stain on them. Pressed in MT A1 and layered with EOP-2, EOP-3 and E-58 mixed with TO 2:1 ratio. I will post more photos of technique and process later. Got to get a few cases out first!I thought it was Al's at the first sight. Very beautiful, thank you for sharing.
This warm appearance , is it stain or powder? Any certain technique?
Sent from my PadFone T008 using Tapatalk
Amd should be, Wonderful case!!![emoji5]View attachment 28617 Here it is directly after cementation. Very happy with the result!
I fire on low end when layered , regular temp when mono then rubber wheel surface to make it smooth then buff with this fiber brillo pad wheel , no diamond pasteGreat work, can I ask what temperature you fire for emax, monolithic and incisal cutback........do you use any sort of glaze material?