Open margin on design

Slimboyphat

Slimboyphat

Member
Full Member
Messages
37
Reaction score
0
1685050535960.png

Here's an issue we're running into with open margins on our veneers. You can see the "no gap" green on the mesial starting to pull away from the model. some reason i can't seem to get a full 1mm width of no gap. So far, its only happening on those sharp mesial and distal edges. any incites on this?
 
CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
go to Undercuts

make sure Protected zone near margin line is set to NON ZERO number

margin will be sealed.
 
Slimboyphat

Slimboyphat

Member
Full Member
Messages
37
Reaction score
0
i adjusted milling diameter which affected it too.. default is 1.2mm.. not entirely sure whats recommended for the ceramill 3 but ill leave this as is and just adjust undercut parameter
 
Last edited:
Top Bottom