B
bentwire42
Member
Full Member
- Messages
- 16
- Reaction score
- 0
Hello everyone,
At the moment i have been making a square cardboard box and lining it with pre tapped masking film painters use. Every couple months i will throw out and replace new film on the interior of the box. It's messy and a bit unsightly and i am concerned about the small particles that go airborne when steam cleaning inside the box.
Has anyone found a cleaner solution to removing wax from removable/fixed appliances before trimming.
I have seen "Zap It" which is a wax substitute and could eliminate wax altogether for holding down wires.
I have also seen a hot water gun that pours boil water that removes wax off models and appliances but it was a large specialized bit of equipment which had separate drainage.
Anyone found a better way?
At the moment i have been making a square cardboard box and lining it with pre tapped masking film painters use. Every couple months i will throw out and replace new film on the interior of the box. It's messy and a bit unsightly and i am concerned about the small particles that go airborne when steam cleaning inside the box.
Has anyone found a cleaner solution to removing wax from removable/fixed appliances before trimming.
I have seen "Zap It" which is a wax substitute and could eliminate wax altogether for holding down wires.
I have also seen a hot water gun that pours boil water that removes wax off models and appliances but it was a large specialized bit of equipment which had separate drainage.
Anyone found a better way?