Tunajoe
Member
Full Member
- Messages
- 98
- Reaction score
- 0
I’m in the process of designing a full upper implant supported zirconia hybrid supported on 5 implants.
I’m using a Amann Girrbach Motion 2 mill and their version of Exocad.
Ive done these before, but this case is having issues with the scanning part.
I mounted the case on a AG Artex articulator and chose that in the work up.
when the program gets where I scan the scan bodies it doesn’t prompt me to scan each implant specifically.
It only does one scan and when finished, and prompted to continue, it will take me to the lower arch.
My other cases will prompt me to scan each implant.
what am I doin wrong?
I’m using a Amann Girrbach Motion 2 mill and their version of Exocad.
Ive done these before, but this case is having issues with the scanning part.
I mounted the case on a AG Artex articulator and chose that in the work up.
when the program gets where I scan the scan bodies it doesn’t prompt me to scan each implant specifically.
It only does one scan and when finished, and prompted to continue, it will take me to the lower arch.
My other cases will prompt me to scan each implant.
what am I doin wrong?