L
LarryRDC
Active Member
Full Member
- Messages
- 308
- Reaction score
- 59
For the optiglaze, I set any staining with a light curing gun, then apply the glaze all over, then throw it in my light curing box for a couple minutes.Thanks! i think that's the best route to go as well. What are you using for curing the optiglaze?
My tech support was able to take me back to the pre cutback stage of the design but we couldn't keep it full contour, it just automatically went back to the saved cutback. Apparently I set it up wrong or did something else wrong. Hashtag "fallingfurtheroutoflovewithexocad."
So I'm going to redo the case and morph to the saved stl of the full contour we were able to make. Yay
Last edited: