M
mr-b
Member
Full Member
- Messages
- 12
- Reaction score
- 1
this how we do it
1-upper bite hight, anterior 22mm and posterior 18(or 6mm) from the
Tiberosity
2-Lowe bite hight is 18mm
3-check each of them in the patient mouth
If you are not using Facebow
4- mark two points, tip of the nose and chin
5-measure the distance between two points, while the patient is relaxed(for example 40mm)
6- orientation grooves placed on either maxillary or mandibular one
7-after placing both upper and lower bite block in the patient mouth, make sure the hight of them in the patient mouth more than (40mm)
8-guide the patient to the most retrided position and let the patient close until the distance is 38mm
9-check that the bite is correct, at least two times 10 minutes apart.
1-upper bite hight, anterior 22mm and posterior 18(or 6mm) from the
Tiberosity
2-Lowe bite hight is 18mm
3-check each of them in the patient mouth
If you are not using Facebow
4- mark two points, tip of the nose and chin
5-measure the distance between two points, while the patient is relaxed(for example 40mm)
6- orientation grooves placed on either maxillary or mandibular one
7-after placing both upper and lower bite block in the patient mouth, make sure the hight of them in the patient mouth more than (40mm)
8-guide the patient to the most retrided position and let the patient close until the distance is 38mm
9-check that the bite is correct, at least two times 10 minutes apart.