K
kmart
Active Member
Full Member
- Messages
- 51
- Reaction score
- 34
What would you guys press a 5m1 3d shade out of? 7,8,9 with about 1.5 mm buccally.
Yes Sir.same with 4M1
Is there any metal on preparated teeth? If no I would use HT D2 and color it till I faint
pardon my ignorance but what kind of material is impulse?is it Ld like e-max?Impulse V1
It is emax. Between LT and HT in translucency.P
pardon my ignorance but what kind of material is impulse?is it Ld like e-max?
I see. Thank you 2thm8krIt is emax. Between LT and HT in translucency.
Do you have multi ingots?Ok. I have a full upper arch in monolithic e.max. Shade 3M1, which I'm calling a C1, with a stump shade of B4 which is close to ND3. The ingot selection wheel is saying HT BL2, LT C1, and then the High and Med Opacity but since he wants mono those two are out. Should I go with LT C1? 3M1 is kinda close to D3 as well so what about LT D2 or D3?
NopeDo you have multi ingots?
Then LT D2 would be my choice. .if you do a lot of this type of cases ,take a look at the multi ingots. They come in really handy and they can turn out really pretty with less effort.Nope
Ok. I have a full upper arch in monolithic e.max. Shade 3M1, which I'm calling a C1, with a stump shade of B4 which is close to ND3. The ingot selection wheel is saying HT BL2, LT C1, and then the High and Med Opacity but since he wants mono those two are out. Should I go with LT C1? 3M1 is kinda close to D3 as well so what about LT D2 or D3?
I don't have any impulse ingots. I think I'm going to use D2 LT and layer some porcelain buccally.