• Welcome to Dental Lab Network
    1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

    Patrick Coon's Recent Activity

    1. Patrick Coon replied to the thread Translucency liquid.

      [ Agreed! All your doing with any of these liquids is lowering the value in those areas with either a blue, gray, or violet to...

      Nov 22, 2017 at 10:13 AM
    2. Patrick Coon rated Ryan Gottlieb's post Agree in the thread Translucency liquid.

      you can create the illusion of more translucency.

      Nov 22, 2017 at 10:07 AM
    3. Patrick Coon rated Sevan P's post Agree in the thread Translucency liquid.

      I had a jar of liquid a few years ago that was supposed to do thhe same thing, don't know what i t was called but never really worked,...

      Nov 22, 2017 at 10:07 AM
    4. Patrick Coon replied to the thread sintering oven problems.

      Shane, is that furnace on it's very own dedicated circuit? no other outlets attached to that circuit in the breakerbox? If not, it...

      Nov 20, 2017 at 4:16 PM
    5. Patrick Coon replied to the thread sintering oven problems.

      He's agreed with a few of my posts, so I'm not sure if I should be honored or afraid. :D

      Nov 20, 2017 at 11:01 AM
    6. Patrick Coon rated Contraluz's post Agree in the thread Porcelaine firing time VS zirconia frame size.

      In the 'battle' of pfm vs. zr, the long firing cycles is one of the drawback... I don't think there is a 'formula'. I increase about 10...

      Nov 17, 2017 at 7:30 AM
    7. Patrick Coon rated Sda36's post Agree in the thread Porcelaine firing time VS zirconia frame size.

      I would suggest even a bit longer, 25-30°/min rise, 2 min hold at high temp. Then a Really slow cool to room temp if we're talking the...

      Nov 17, 2017 at 7:29 AM
    8. Patrick Coon rated PDC's post Agree in the thread Porcelaine firing time VS zirconia frame size.

      My furnace has 2 selectable cooling positions and will hold the crowns at those positions until temps drop back to entry level. Heat...

      Nov 17, 2017 at 7:29 AM
    9. Patrick Coon replied to the thread Emax fractures and glaze.

      Hey Car54! No, the Fracture Toughness stayed the same at 2.75.

      Nov 16, 2017