Trios-scanbody for design but for now

  • Thread starter prestige.dental
  • Start date
prestige.dental

prestige.dental

Active Member
Full Member
Messages
270
Reaction score
15
so we are designing form trios-scanbody pathway, but cementation to tibases is on a stone cast from PVS-impression coping closed test impression---- for single units.


We don't do trios scanbody for more than one implant due to trios image stitching inaccuracy

Haven't entered into printing implant models

Due to printer being too expensive

And not having enough confidence in the accuracy of printed models

Guys is this what you guys are doing too.

Or we are legging behind.
 
CoolHandLuke

CoolHandLuke

Idiot
Full Member
Messages
10,078
Solutions
1
Reaction score
1,411
you are hum and haw over nothing. trios stitching inaccuracy ? what are you talking about? thousands of labs over the globe are using this technology and printing and finding not a whole lot to be concerned about.

where are you getting your facts? is there some alternate fact dental site i should be checking?
 
prestige.dental

prestige.dental

Active Member
Full Member
Messages
270
Reaction score
15
you are hum and haw over nothing. trios stitching inaccuracy ? what are you talking about? thousands of labs over the globe are using this technology and printing and finding not a whole lot to be concerned about.

where are you getting your facts? is there some alternate fact dental site i should be checking?

Hello Luke:


Thanks for your post. It's very enlightening. We have to fix what we are doing wrong and get back to believing in trios and put this 45k investment to proper use.
 
Top Bottom