Discussion in 'Case Presentations' started by Al., Oct 13, 2011.
Sounds legit. It is definitely easier to handle and the margins thin without chipping
Wax and press full contour, make matrix, manual cut back , bond coat
No laterals Cuspids in their place
Minimal 3 powder layer
Al, would you recommend doing 8,9 veneers in an MT BO? Im going to layer the facial, but my free HT ingots have taken forever to get here and I need to press these..
did you see the other case I posted today ?
The 4 Anteriors with 9 an implant ret crn ?
Those were all pressed in BO.
7 was a veneer
I will put it here but I'm not at my computer now
I was hoping there would be more posts between Al's work and mine to separate us a little more . He's a tough act to follow.
This case was a zirconia bridge layered with Emax. Considering what the patient had, it wasn't too hard to please her, especially after the extractions of #7,8,9,10. The doctor's camera flash kind of made everything look brighter than what it actually was but it turned out ok.
Separate names with a comma.