Restorations Du Jour

Al.

Al.

Well-Known Member
Full Member
Messages
3,664
Reaction score
904
I extended the pressing with straight incisal and with some Trans Opal
The incisal is more lingual.
Then added High Flo Mammelon porc and fired
Then incisal.
So sandwiched the dentin/mm's but left sharp line of demarcations on the D and M to give that halo type look
 
PDC

PDC

Well-Known Member
Full Member
Messages
997
Reaction score
232
I extended the pressing with straight incisal and with some Trans Opal
The incisal is more lingual.
Then added High Flo Mammelon porc and fired
Then incisal.
So sandwiched the dentin/mm's but left sharp line of demarcations on the D and M to give that halo type look

Al, it sounds like you have abandoned your open face design of your crowns where you would cut a window in the facial of your crowns. Have you experienced any chipping at the incisal edges since changing your design?
 
RDA

RDA

Well-Known Member
Full Member
Messages
942
Reaction score
192
It is official the launch date will be November 14th, according to my rep.

14692180_10154450077527891_6724165430887510079_o.jpg
 
Car 54

Car 54

Well-Known Member
Donator
Full Member
Messages
7,974
Reaction score
1,122
Even using the same opacity/translucency system as emax o_O I wonder how close they are, so we could just go from emax LT to LiSi LT, MT to MT etc?
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Messages
21,410
Reaction score
3,288
Even using the same opacity/translucency system as emax o_O I wonder how close they are, so we could just go from emax LT to LiSi LT, MT to MT etc?
assuming the diameter of the ingot is the same.
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
Messages
11,304
Reaction score
2,510
assuming the diameter of the ingot is the same.
I would be a bad call if they weren't the same diameter. Moving in on someone's turf is easier if you make it easier for the user to defect to the other side.
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Messages
21,410
Reaction score
3,288
I would be a bad call if they weren't the same diameter. Moving in on someone's turf is easier if you make it easier for the user to defect to the other side.
The GC page on facebook is just pics and high 5's. No info at all.
 
Al.

Al.

Well-Known Member
Full Member
Messages
3,664
Reaction score
904
LiSi Press
BO MT Ingot
3 Powders layered... B1, TO , Inc 58
B1 to fill out any gin 1/2 undercontoured areas TO to fill in irregular cut back than Inc 58 over that.

IMG_9482 - Copy.JPG
IMG_9488 - Copy.JPG
IMG_9490 - Copy.JPG
IMG_9491 - Copy.JPG
IMG_9492 - Copy.JPG
IMG_9502 - Copy.JPG
IMG_9508 - Copy.JPG
IMG_9509 - Copy.JPG
 
Last edited:

Similar threads

CatamountRob
Replies
6
Views
779
bigj1972
bigj1972
I
Replies
17
Views
289
Flipperlady
Flipperlady
J
Replies
5
Views
882
jesusdesinger10
J
J
Replies
1
Views
328
Amr Zakaria
A
Top Bottom