Printing wax up made in exocad

tehnik

tehnik

Active Member
Full Member
Messages
506
Reaction score
12
Hi

I have this strange problem. I created a waxup in the exocad and everything is ok until I try to create model out of it. I will attach pictures of the problem. Any idea how to solve it?

1.JPG 2.JPG 3.JPG
 
2thm8kr

2thm8kr

Beanosavedmysociallife
Full Member
Messages
11,304
Reaction score
2,510
There are too many shells for model creator to render a clean model. Use the editor to cut the pontic bottoms off and the gingival area where the pontics contact and run through model editor again.
 

Similar threads

Top Bottom