New 3d printer

[[email protected]]

Any thoughts on the new miicraft printer? Not sure of the potential to cleanly burn out their blue resin. But under 2000 for a set up. Nice z axis res. I use reprap for pla print. It does nice patterns and good jaw prints. I cast implant locator frames. Scan locator clips, Exocad splint module designs frames, print in 30 min, cast, lute, insert. Too easy. But this new miicraft looks very good......like asiga


---
I am here: http://tapatalk.com/map.php?rury3f

 

[YMS96]

Any thoughts on the new miicraft printer? Not sure of the potential to cleanly burn out their blue resin. But under 2000 for a set up. Nice z axis res. I use reprap for pla print. It does nice patterns and good jaw prints. I cast implant locator frames. Scan locator clips, Exocad splint module designs frames, print in 30 min, cast, lute, insert. Too easy. But this new miicraft looks very good......like asiga


---
I am here: http://tapatalk.com/map.php?rury3f

There's ton of these printers coming out. Also check out the b9 creator (further along than the Miicraft). Envisiontec is also releasing a smaller model under $15k.

B9Creator™ - What will YOU create?
EnvisionTEC