Search results

I do need a design only for post core and crown, I can send it by STL. Let me know how much and I can pay by PayPal or credit card over the phone. Texte 2048690066 Baher Thanks

I do need a design only for post core and crown, I can send it by STL. Let me know how much and I can pay by PayPal or credit card over the phone. Texte 2048690066 Baher Thanks

Mish has beet cut, noraml bite set up. Case deliver today. Thanks Sent from my SM-N900W8 using Tapatalk

I am not sure but I'll try to do set up with the existing bite and to see if it is doable. I'll cut the mesh Sent from my SM-N900W8 using Tapatalk

I hope this make the idea more clear Sent from my SM-N900W8 using Tapatalk

Good morning, Trying to challenge this case. Patient has severe attrition, bite collapsed. The cast guy recommend this design. My target to increase the VDO 4mm What do you think about this design Thanks Sent from my SM-N900W8 using Tapatalk

Diamond henry schein And impact for the thermoflex Sent from my SM-N900W8 using Tapatalk

this how we do it 1-upper bite hight, anterior 22mm and posterior 18(or 6mm) from the Tiberosity 2-Lowe bite hight is 18mm 3-check each of them in the patient mouth If you are not using Facebow 4- mark two points, tip of the nose and chin 5-measure the distance between two points, while the...

Thanks KCDT Yes it is the one become soft in water . How about the one for interra for dentsply is it the same oe not.

I have dentist asking about thermoflex night guard. How we make the thermoflex night guard. Thanks

hi, I do not have experience fabricating THERMOFLEX night guard, i think it is the one become soft in hot water. thanks

you should use warm water, around 40 degree cellulose, with pressure 22psi. But, with my experience in the pressure goes down, nothing happen. some technician use to use cooking pressure pot, adding safety bleeding valve, pressure gauge and intake valve. It will be pretty cheap comparing to our...