Search results

Where exactly would one look to see this info within the software......?

Looks like the Clon 3D wand that has YET to be released....

What kind of bars? Ti.....Zr?

Where did u get that pic? Why didn't 3M submit that for the Lava mill too? WTF? and yea......over implants? sounds strong? permanant? resin?

Keep in mind, a lot of "fee for service" dentists are now taking dental insurance.....so in an effort to keep their practice up with patient volume, they are also having to fit in their overhead and lab expenses within a $450-600 crown pay out by insurance, while some plans allow balance billing...

Shameful, isn't it?

Try $18.00 for non-precious PFM. It's out there in China. $15.00 PFM"s plus the cost of alloy.............what now?popcorn

say hello to ***....

I am only a member of my state lab association. The NADL membership I will do this fall....I have a budget set up and needed to do my state membership first. I am a new lab within the last year, so I am tight with money...although I did take a hit and buy the DAMAS manual from NADL.

I am looking for labs who are doing a lot of emax and zirconia....have chatted loosely to Ivoclar about being a supplier member and I have a milling center interested in this idea too. I am trying to get good labs to join us in making our industry more stable and keep work in our...

I only glaze in mine......

Any medium sized labs interested in a possible option other than reducing your fees due to dental insurance pressures, private message me and I will fill you in on a new concept. This is something new to dental, currently in the works and we arelooking for other labs who want to participate in a...

Maybe not cleaned or dusted off enough before coloring and sintering.....

Same as a PFZ, since it has a ceramic substrate, I asked around and this was the answer I got over and over, so I go with it

Have done Zirkonzahn and Pearl Zr from CMC, Pearl HT is the best I have seen so far and I have done a number of them with the dotors calling to say how good they looked. Would like to see the Prettau liquids,the incisal colors, used on the Pearl, not sure what CMC uses to color the Pearl Zr. I...

FDA Schmefda.......they are lazy and clueless

Smooth surface with a diamond, rubber wheel the high spots to smooth surface texture, blast with 50 mic aluminum oxide, clean, stain, fire, glaze, fire, I hit with a rubber wheel at the end and some diamond paste. You may need to calibrate your oven first, then consider raising your high temp...

I use GC press to Zr for shades that need to be brighter, higher in value, and I use Zirpress most of my regular shades, A1-D4, hand layered porcelain on ZR is pointless because they never look translucent enough.....hence press using ONLY High Trans ingots pressed a shade lighter. You guys are...

I don't layer at all on Zirconia...Zirpress HT press down a shade, final shade A2....Zr coping shaded for A2.....clear Zirliner.....Press out of Zirpress HT A1....add some stain at margins and glaze....done.

I do Atlantis abutments with Lava ST scanner.....about 7 mins total from entering case info, scanning the parts, to sending file, not too bad.