G
gold999
Member
Full Member
- Messages
- 23
- Reaction score
- 0
I'm just about to press my first case using the MT ingot.
I know you use the same program in the Zubler Vario Press, as you would pressing the HT ingot.
I don't use the LDS Zubler program.
In the Ivoclar info, the HT ingots press 5* lower than the LT
I've never pressed an HT emax ingot, just the HT ZirPress.
I've modified the low temp of the LT program quite a bit from the original temp.
Maybe I can just lower the HT program accordingly.
Going to do test press case anyway
Thanks alot
I know you use the same program in the Zubler Vario Press, as you would pressing the HT ingot.
I don't use the LDS Zubler program.
In the Ivoclar info, the HT ingots press 5* lower than the LT
I've never pressed an HT emax ingot, just the HT ZirPress.
I've modified the low temp of the LT program quite a bit from the original temp.
Maybe I can just lower the HT program accordingly.
Going to do test press case anyway
Thanks alot