Quote:
Originally Posted by trisha
I used to put the monomer on 1st then the polymer and not the other way around. I later realized the importance of using polymer 1st on the model.
|
I have heard to do it both ways never have realy found a good reason. Do you soak you models completly or do a wash before seperator, like Labdue?
Quote:
Originally Posted by trisha
I have noticed that if I do make the lower too thick when I go to hone it down with an egg burr i& pumice it can make the acrylic pull away slightly from the model.
|
I was thinking this was the cause too for a while , like when I used the acrylic knock down wheel for bulk trim, that the acrylic was getting too hot and distorting. I guess with the combination of this acrylic this i might not be good. Looks like thick acrylic is the culprit, I have been monitoring that the pas couple of days and no shrinkage.
Cade